Wire brush wall mount

Description

I don't like getting poked by my wire brush when it's in my tool bag. Thus I created this so I could leave it hanging on a wall outside of my bag. It's not something I use often, so that is why its just a wall mount instead of a "carry case." Print setting - I think you should print it at 110% because it's a bit too tight of a fit. - 10% cubic infill if you want Mounting - I did not include a screw hole, i manually drilled a hole in the back. - You can also use doublesided tape I am the owner of https://www.neocrisis.com/